Back

Canon New F-1

Half clockwork, half electronic

  1. The shutter is a horizontal-travel titanium focal-plane unit with hybrid control . The fast end — 1/2000 to 1/125 , plus S (1/90, flash sync) and B — is timed mechanically. The slow end, 1/60 to 8 s , is timed electronically.
  2. So if the battery dies, take it out : the camera switches to mechanical release and all the mechanical speeds work. Set a slow speed with no battery and the shutter fires at 1/90. Leave a dead battery inside and the camera won't work at all.
  3. On the dial, 1–1/2000 are white, 2–8 s yellow, and the red A appears only with the AE Finder FN.
  4. Shutter dial — 2000 to 8, A, S, B; R for rewind

The screen decides what the meter sees

  1. Inside each interchangeable focusing screen sits a micro beam splitter : a special optical element close to the focal plane that sends part of the image to the silicon cell. Its pattern sets the metering area — so swapping the screen swaps the meter.
  2. Centre-weighted average reads the whole frame, favouring the middle; recommended for AE. Selective-area reads the central 12 % ; good for backlight and bright skies, best used in manual. Spot reads 3 % ; for stage, telephoto, close-ups — manual only. With selective and spot, the area shows faintly shaded in the finder.
  3. Micro beam splitter — in the screen, feeding the SPC cell
  4. Tap or drag to aim the camera's metering area. Photograph from the manual.
  5. Calculated from the pixels of the manual's photograph: the image is re-exposed so the metered area lands on mid-grey. Patterns are the manual's own diagrams.

Add a part, gain a mode

  1. The bare body is a match-needle manual camera: centre the needle on the aperture scale at the right of the finder. Automation is bolted on. Tap the accessories.
  2. Safety interlock: with the lens on A and no power drive attached, the shutter will not release.

Speed, aperture, two exposures

  1. f/1.4 ⟷ f/22 — depth of field; drag
  2. Multiple exposure — clock and rose on one frame
  3. After the first exposure, engage the rewind lever before winding: the shutter recocks but the film stays put. A light press of the shutter button cancels it.
  4. Exposure for each shot has to be reduced so the total isn't too dense. The manual's guide on the compensation dial: for two exposures, set each at ½ ; for four, ¼ — the dial is marked 1/4, 1/2, 1, 2, 4 alongside the ±2 stops in thirds.
Loading Canon New F-1…