The FE2 has a vertical-travel metal focal-plane shutter with titanium curtains , electronically controlled. Two curtains cross the frame one after the other. At slow speeds the first is gone before the second starts, so the whole frame is open at once.
At fast speeds the second curtain chases the first, and the film is exposed through a moving slit . Every point of the frame still gets 1/4000 s — but never all points at the same moment.
That is why flash needs the sync speed, 1/250 s : the fastest speed at which the frame is fully open for an instant. Faster, and the flash's burst lights only a band.
Top plate — speed dial: A, M250, B, 8 s to 1/4000; ISO and compensation dial at left
Slow motion — the film gate seen from behind the lens
The curtain travel time is illustrative (about 3.6 ms across the 24 mm frame). The slit widths follow from it; the principle — full opening only at 1/250 and slower — is the camera's.
Daylight fill at 1/250
The hot shoe has four contacts: sync, automatic flash output stop , identification of a TTL unit, and the ready-light plus auto speed switching. With an SB-15 or SB-16B in TTL, the camera measures flash light off the film during the exposure and stops the flash when it's enough.
Turn a dedicated flash on at A or 1/500 and faster and the camera switches itself to 1/250 . For fill flash you can set 1/250 or slower yourself. The ready-light in the finder lights when the flash has recycled and blinks to warn of too little output or a wrong setting.
The manual's demonstration: the same throw, same fill flash. At 1/60 the daylight records a blur; at 1/250 the motion is stopped.
Sync table — electronic flash synchronises at 1/250 and slower, M250 and B
At M250 and B the flash works even with dead camera batteries; the ready-light still shows.
1/60 s — daylight fill-in does not freeze the model aeroplane
1/250 s — all movement is stopped
Same light, many answers
On A you choose the aperture and the FE2 sets any speed from 8 s to 1/4000, steplessly; a green needle shows the dial setting, a black needle the meter's choice. Turn the aperture ring while watching the black needle and you can effectively shoot shutter priority .
Every pair on the line below gives the same exposure. Faster speed freezes; smaller aperture deepens focus. The manual's own table: 1/4000 at f/2.8 = 1/1000 at f/5.6 = 1/125 at f/16 .
Needle between 1/30 and 8 s : open up, use a tripod, flash or faster film. Needle in the upper red zone : stop down or use an ND filter. Lower red zone : open up, flash, or B.
M250 fires mechanically at 1/250 and B stays open as long as you hold — both without batteries.
The manual's suggested settings. Limits at the ends of the film speed scale: at ISO 12 only +1, at ISO 16 +1⅓; at ISO 3200 only −1⅓, at ISO 4000 −1. The memory lock lever holds a reading instead.