Olympus Trip 35
The ring of bubbles is the light meter
- The textured ring around the lens is not decoration. Behind its moulded lenslets sits a selenium photocell , which turns light directly into a small current. That current swings a meter needle. Nothing needs to be switched on and there is no battery compartment anywhere on the camera.
- Because the cell faces the same way as the lens, it reads the scene you are pointing at. The booklet gives the meter's range as EV 8.32 to EV 17.14 at ASA 100 — from a bright interior to snow under full sun.
- Set the film speed first: turn the ASA ring on the front of the lens barrel until your film's number shows in the window. The scale runs ASA 25–400 (ASA = today's ISO). For ASA 32 film, use the dot marked 40.
- Selenium cells tire with decades of light. A Trip that locks with the red flag in good daylight usually has a weak cell, not a bad shutter.
- Generates current in proportion to the light falling on it.
- The needle settles at a position that encodes scene brightness.
- Pressing the release clamps the needle; its position sets the aperture and speed.
- The shutter opens at 1/40 or 1/200. Too little light: the release stays locked.
Fig. 1/8 — Ring in front of the lens; red line is the index
Two speeds, one sliding aperture
- With the aperture ring on A , the Trip picks everything. In dim light it holds 1/40 s and opens the lens towards f/2.8. Once the light is strong enough it jumps to 1/200 s and closes down towards f/22. Below the meter's limit, a red flag rises in the viewfinder and the shutter button will not go down.
- Drag the light level. The chart shows the aperture the Trip chooses; the colour of the line shows the shutter speed. Changing the film speed shifts the whole programme, because faster film needs less light for the same result.
- The booklet gives the endpoints: 1/40 at f/2.8 and 1/200 at f/22, meter range EV 8.32–17.14 at ASA 100. The changeover point is not in the booklet; about EV 13 is the figure quoted by repairers, and the curve between the endpoints is derived from it.
Focus by picture, not by distance
- The focusing ring carries four symbols: one head (portrait), two people , a group , and a mountain (landscape). Estimate the distance, turn the ring until the right symbol is on the red line, and shoot.
- The chosen symbol also appears in a small window at the lower right of the viewfinder , so you can set focus without taking the camera from your eye.
- For flash or careful focusing, use the metre (white) and feet (yellow) scales under the symbols. The ring stops at each end — it does not turn 360°.
- Zone distances (1 m, 1.5 m, 3 m, ∞) are the commonly published values for the Trip's symbols. Depth of field is calculated for 40 mm with a 0.03 mm circle of confusion. On A you don't choose the aperture: in bright sun it is small and nearly everything is sharp; in shade it opens up and the zone matters.
Fig. 9 — The four symbols; below, the aperture ring at A
A bright frame and a red flag
Fig. 10 — Booklet photograph through the finder, with the warning flag up
Off A, the Trip becomes manual
- Turn the aperture ring away from A to any f-number. The automatic system switches off, the shutter is fixed at 1/40 s , and it releases whatever the light — the flag no longer blocks it. The aperture scale is marked “for Flash” .
- The hot shoe has a cordless centre contact for flashes such as the Olympus Pen Flash CL (AG-1 bulbs). Other units connect through the PC sync socket.
- Choose the aperture with the flash's guide number: f-number = guide number ÷ distance . Focus with the metre scale, not the symbols.
Fig. F2 — ASA window, symbols, aperture scale “for Flash”
Fig. F3 — Pen Flash CL slides on; no cord needed
Three things worth knowing
- Pull the leader across and push its end into any of the six slots on the take-up spool. Check that both edges' perforations sit on the sprocket teeth before closing the back.
- The thumbwheel on the back advances the film and cocks the shutter. Fire and wind two or three times until the counter shows 1 . Always wind to the stop — never half way. The counter resets itself when the back opens.
- At 36, 20 or 12 (by cassette), stop. Press the rewind button on the bottom , lift the crank and turn until it goes slack. Change film in the shade of your own body, never in direct sun.