Back

Olympus XA

The shell is the on switch

  1. The sliding front cover — Olympus calls it the Dust Barrier — protects the lens and finder windows, and it is also the camera's power switch. Fully open: power on , everything works. Closed: power off , the release is locked, the batteries rest.
  2. Half-open is the classic beginner's trap: if the barrier isn't fully open, the shutter won't release. Close the barrier before rewinding.
  3. The shutter button is an electronic feather-touch release made of pressure-conductive polymer. It fires with very little pressure — no long stroke, so less shake.
  4. Fig. 1 — Description of controls, front

You pick the aperture. A needle shows the speed.

  1. Move the aperture lever on the front (f/2.8–f/22). The XA sets the shutter speed electronically, anywhere from 10 s to 1/500 s , and a needle on the scale at the left of the viewfinder shows what it chose.
  2. Needle in the striped zone at the top: over-exposure — push the lever down to a smaller aperture until it points to 500 or below. Needle at 30 or lower : steady the camera, open the aperture, or use the flash.
  3. Fig. 16 — The finder in the manual; the scale at left is redrawn live
  4. Fig. 16 — The aperture lever slides vertically
  5. The control lever under the camera has three jobs. BACK LIGHT +1.5 adds 1.5 stops for faces against bright sky, sand, snow or a window — the same as lowering the ASA setting. SELF TIMER fires after about 12 seconds, with a beeper and blinking lamp; the lever also props the camera up. CHECK tests the batteries: beeper sounds and the lamp glows.
  6. Power is two SR44 silver-oxide cells (also sold as EPX-76 / 357), good for about a year. Don't press the release during the battery check.

Two images become one

  1. In the centre of the finder is a small rectangle with a second, offset image. Push the focusing lever under the lens until the two images fuse — then the subject is in focus. Focus runs from 0.85 m (2.8 ft) to infinity . The knurled lens mount also turns, which is handy on a tripod.
  2. At 0.85–1 m, frame below the two parallax marks : the finder sits above and to the side of the lens.
  3. Try it: the subject stands at 2 m. Slide until the ghost locks onto her. Depth of field below uses the aperture from section 02.
  4. Fig. 8 — Focusing lever under the lens
  5. Depth of field for 35 mm with the manual's 1/30 mm circle of confusion. Check against the booklet: 1 m at f/4 gives 0.91–1.12 m.

What the lever actually changes

  1. Fig. 13 — Out-of-focus background vs deep focus
  2. Wide open, only the face is sharp. Stopped down, the harbour comes into focus too — and the XA lengthens the shutter speed to compensate.
  3. Fig. 15 — Emphasise motion vs stop it
  4. Shutter-speed priority on an aperture-priority camera: watch the needle and move the aperture lever until it points to the speed you want.

A flash that bolts to the side

  1. Only the A11 fits. Insert its guide pin, turn the clamping screw clockwise, and push the aperture lever up past f/2.8 to Flash — the position needs a firmer push on purpose. The charge lamp pops up and the A11 switches on; when it glows, shoot.
  2. On auto the XA shoots at f/4 . The A11 has guide number 10 (m, ISO 100) and works with ASA 100 or 400 only — use the nearest setting (80 or 125 → 100). Press the charge lamp down to switch off.
  3. Fig. 12 / 2 — Lever at Flash, charge lamp up · the A11
Loading Olympus XA…