Back

Rollei B35

Four moves, in one order only

  1. The B 35 is carried with the lens pushed in and the shutter already wound . While the lens is in, the release is locked.
  2. To shoot: pull the lens out and twist it to its stop . Now release and wind alternately. To put it away the lens only goes back in with the shutter wound : wind, hold the button with the red dot , twist the lens to unlock and push it in.
  3. The manual sums it up: a system of interlocks means you can only work the camera one way — the right way. Try it.
  4. Fig. 6 — Pull out and lock (1), release (2), wind (3), red dot (5), push in (4)

Read the needle. Set the lens.

  1. The round meter on the top plate is a selenium cell : it makes its own current, so there's no battery. It is not linked to the lens — you transfer its reading by hand.
  2. Needle off the scale? Pick another speed. No movement at all? The light is too weak for the cell.
  3. Fig. 12 — Film speed (1), speed index (2), aperture read and set on the lens
  4. The simulated meter follows the exposure equation; the scales are the B 35's: speeds B, 30–500; apertures 3.5–22 with click stops between.

Three rings on one barrel

  1. Ring 1 sets the shutter speed, ring 2 the aperture, both against a shared index. Ring 3 sets the distance in metres from above; a second scale underneath reads in feet. The bright frame in the finder shows the picture area, and short marks inside it show the limits for subjects closer than 1.5 m.
  2. Either side of the focusing index are two pairs of dots: the inner pair for f/8 , the outer for f/16 . Whatever lies between the dots on the distance scale is sharp.
  3. Two distances are engraved in red for snapshots at f/8 or smaller: 2 m (6½ ft) covers about 1.5–3 m, 6 m (20 ft) covers 3 m to infinity. Set one and forget focusing.
  4. Fig. 10 — Speed (1), aperture (2) and distance (3) rings
  5. Calculated for the Triotar 40 mm with the 0.025 mm circle used in the manual's depth-of-field table; the values match the printed table (e.g. 6 m at f/8: about 3.5–23 m).

Slowest safe speed, by subject

  1. The speed ring clicks at 30, 60, 125, 250 and 500 — fractions of a second; nothing in between. Hand-held, 1/30 is the longest you should risk; 1/60 and 1/125 are safer. Moving subjects need the speeds below. The further away the subject, and the more it moves toward you rather than across, the less it blurs.
  2. From the booklet's guide figures. B holds the shutter open as long as the button is down — use a cable release and a tripod.

The back comes right off

  1. Fig. 8 — Flange (1), spool (2), cartridge (3), pressure plate (4), back lock (5, 6), transport disc (7)
  2. While winding, the disc (7) on the base turns. If it doesn't, the film isn't transporting — reload.
  3. Fig. 16 — Rewind button (1) and crank (2) on the base
  4. Is there film inside? Unfold the crank and turn it gently: resistance means loaded; free spin means empty.

Leaf shutter, centre contact

  1. The accessory shoe has a centre contact for cordless flash; units with a cord need an adapter with a coaxial socket. With a leaf shutter, electronic flash syncs at every speed up to 1/500 . Flash bulbs need 1/30 or slower .
  2. Filters screw into the lens mount. The correction engraved on the filter is in stops: on the aperture ring one click is half a stop, on the speed ring one click is a full stop. Rollei's medium yellow needs −1.5.
  3. The C 35 was the same camera without the meter. Its users got the table on the right: 1/125 at ASA 50–64, light (1–3) against subject (A–D). Example: full sun, landscape with foreground — f/16. It still works on a B 35 whose cell has died.
  4. Fig. 14 — Rollei C 35 exposure table; bottom row converts film speed to shutter speed
Loading Rollei B35…